800 m2 of retail space in Anzegem
12,000 products in stock
professional service
pay safely
Kenotek Snow Foam Shampoo 1L
In stock
Ref.: 03408667
Kenotek Snow Foam Shampoo is a highly concentrated pH neutral foam shampoo. Suitable for all foam lances and foamers. Does not affect the existing protective layer. Perfect as a pre-wash to loosen coarse dirt and remove it safely. Can be used both by hand via a hand foamer and a foam lance for a high-pressure cleaner. • Safe for all surfaces • pH neutral formula • Green Apple scent Suitable for all foam lances and foamers Snow Foam Shampoo can be applied via a foam lance, hand foamer or spray bottle. The minimum recommended PIR (panel impact ratio) is 0.5% to a maximum of 2% for very dirty vehicles. The dilution in a hand foamer or spray bottle is easy to determine. For foam lances it is more difficult to determine because it depends on the water flow of the high-pressure cleaner. You only have to do the following once, do not forget to note the ratio on the packaging for the next time. Fill the mixing bottle with tap water to the maximum level. Set the foam lance or, if you are using the reservoir of the high-pressure cleaner itself, to maximum supply of product. Take an empty large bucket and spray with the foam lance connected into the bucket until the entire mixing bottle is empty and stop immediately. If the bottle is not empty and the bucket is full, halve the amount of water in the mixing bottle and start again. All the numbers below must also be halved. The following calculation gives a PIR of 2%. Measure the total number of litres in the bucket after the mixing bottle is empty. Multiply this number by 0.02. The number you are left with is the amount of product you need for the contents of your mixing bottle. Mix the bottle with the desired amount of product and water. Foam the car and let it soak in for 1-5 minutes. Never let the product dry. Then spray off with high pressure. Calculation example with a high-pressure cleaner and a Monello Lancia Foam Lance with 1000 ml mixing bottle. Fill the mixing bottle completely with tap water (1000 ml). Mount the foam lance on the high-pressure cleaner and turn the knob on top completely closed (maximum foam setting). Spray into an empty large bucket until the 1000 ml mixing bottle is (almost) empty. Once the bottle is almost empty, the bucket is filled with 13 litres of water. The amount of product is then 13 x 0.02 = 260 ml and the rest with water. You do not have to use everything you mix, the mixture can be stored. Of course you can also use half by mixing 130 ml of product and 240 ml of water. With a liter of mixture you can do about 8-10 washes depending on your high-pressure cleaner and water pressure.
Additional information
